Endress+Hauser iTEMP TMT162 - Remote Mounting

iTEMP TMT162 Installation
Endress+Hauser 13
6. Guide the fieldbus cables (5) through the cable gland of the fieldbus transmitter
housing into the connection compartment.
7. Screw the cable gland tight as described in the Ensuring the degree of protection
section→  20. The cable gland must meet explosion protection requirements.
4.2.2 Remote mounting
1
3
2
25 (0.98)
180
(7.1)
160
(6.3)
!51
(2.01)
M10
10.5
(0.41)
72 (2.8)
72 (2.8)
56
(2.2)
M10
M10
≤ 50
(1.97)
A0027188
 3 Installation of the field transmitter using the mounting bracket, see chapter 'Accessories'. Dimensions in
mm (in)
1
Mounting with combined wall/pipe mounting bracket
2 Mounting with pipe mounting bracket 2"/V4A
3 Mounting with wall mounting bracket