Endress+Hauser iTEMP TMT162 - Post-Connection Check

iTEMP TMT162 Wiring
Endress+Hauser 21
5.6 Post-connection check
Device condition and specifications Notes
Is the device or cable undamaged (visual inspection)? --
Electrical connection Notes
Does the supply voltage match the specifications on
the nameplate?
Standard mode and SIL mode: U = 11.5 to 42 V
DC
Do the mounted cables have adequate strain relief? Visual inspection
Are the power supply and signal cables correctly
connected?
→  17
Are all the screws terminals sufficiently tightened? →  15
Are all the cable entries installed, tightened and
sealed?
→  20
Are all the housing covers installed and tightened? →  24