Operating options iTEMP TMT162
26 Endress+Hauser
The configuration in the SIL mode is different from the configuration in the standard
mode. For more detailed information please refer to the Functional Safety Manual
(SD01632T/09).
Submenus and user roles
Certain parts of the menu are assigned to certain user roles. Each user role corresponds to
typical tasks within the lifecycle of the device.
User role Typical tasks Menu Content/meaning
Maintenance
Operator
Commissioning:
• Configuration of the measurement.
• Configuration of data processing (scaling,
linearization, etc.).
•
Configuration of the analog measured value output.
Tasks during operation:
• Configuration of the display.
• Reading measured values.
"Setup" Contains all parameters for commissioning:
• Setup parameters
Once values have been set for these parameters, the
measurement should generally be completely
configured.
• "Advanced setup" submenu
Contains additional submenus and parameters:
– For more accurate configuration of the
measurement (adaptation to special measuring
conditions).
– For converting the measured value (scaling,
linearization).
– For scaling the output signal.
– Required in ongoing operation: configuration of
the measured value display (displayed values,
display format, etc.).
Fault elimination:
• Diagnosing and eliminating process errors.
• Interpretation of device error messages and
correcting associated errors.
"Diagnostics" Contains all parameters for detecting and analyzing
errors:
• Diagnostic list
Contains up to 3 currently active error messages.
• Event logbook
Contains the last 5 error messages (no longer active).
• "Device information" submenu
Contains information for identifying the device.
• "Measured values" submenu
Contains all current measured values.
• "Simulation" submenu
Used to simulate measured values, output values or
diagnostic messages.
• "Device reset" submenu
Expert Tasks that require detailed knowledge of the function
of the device:
• Commissioning measurements under difficult
conditions.
• Optimal adaptation of the measurement to difficult
conditions.
• Detailed configuration of the communication
interface.
• Error diagnostics in difficult cases.
"Expert" Contains all parameters of the device (including those
that are already in one of the other menus). The
structure of this menu is based on the function blocks
of the device:
• "System" submenu
Contains all higher-level device parameters that do
not pertain either to measurement or the measured
value communication.
• "Sensor" submenu
Contains all parameters for configuring the
measurement.
• "Output" submenu
Contains all parameters for configuring the analog
current output.
• "Communication" submenu
Contains all parameters for configuring the digital
communication interface.
• "Diagnostics" submenu
Contains all parameters for detecting and analyzing
errors.
To Next Page
Loading...
