Endress+Hauser iTEMP TMT162 - Operating Menu and Parameter Description; Setup Menu Parameters

Operating menu and parameter description iTEMP TMT162
62 Endress+Hauser
14 Operating menu and parameter description
The following tables list all the parameters in the "Setup", "Diagnostics" and "Expert"
operating menus. The page number refers to where a description of the parameter
can be found.
Depending on the parameter configuration, not all submenus and parameters are
available in every device. Information on this can be found in the parameter
description under "Prerequisite". The parameter groups for the Expert setup contain all
the parameters of the "Setup" and "Diagnostics" operating menus, as well as other
parameters that are solely reserved for experts.
This symbol indicates how to navigate to the parameter using operating tools (e.g.
FieldCare).
Configuration in the SIL mode differs from the standard mode and is described in the
Functional Safety Manual.
For more information please refer to the Functional Safety Manual SD1632T/09.
Setup → Device tag →  69
Unit →  69
Sensor type 1 →  69
Connection type 1 →  70
2-wire compensation 1 →  70
Reference junction 1 →  70
RJ preset value 1 →  71
Sensor type 2 →  69
Connection type 2 →  70
2-wire compensation 2 →  70
Reference junction 2 →  70
RJ preset value 2 →  71
Assign current output (PV) →  71
Lower range value →  72
Meas. range end →  72
Setup → Advanced setup→ Enter access code →  73
Access status tooling →  74
Locking status →  74
Setup → Advanced setup→ Sensor → Sensor offset 1 →  75
Sensor offset 2 →  75
Drift/difference mode →  75
Drift/difference alarm delay →  75
Drift/difference set point →  76
Sensor switch set point →  76
Setup → Advanced setup→ Current output → Output current →  77
Failure mode →  77