Operating menu and parameter description iTEMP TMT162
80 Endress+Hauser
Display text n
1)
1) 1, 2 or 3 - depends on the display value set
Navigation Setup → Advanced setup → Display → Display text n
Expert → System → Display → Display text n
Description Display text for this channel that appears on the screen in the 14-segment display.
User entry Enter the display text: the maximum text length is 8 characters.
Factory setting PV
Decimal places 1 (decimal places 2 or 3)
Navigation Setup → Advanced setup → Display → Decimal places 1 (decimal places 2 or 3)
Expert → System → Display → Decimal places 1 (decimal places 2 or 3)
Prerequisite: A measured value is defined in the parameter Value 1 display (Value 2 or 3 display)
→ 79.
Description Use this function to select the number of decimal places for the display value. This setting
does not affect the accuracy of the device for measuring or calculating the value.
If Automatic is selected, the maximum possible number of decimal places is always
shown on the display.
Options • x
• x.x
• x.xx
• x.xxx
•
x.xxxx
• Automatic
Factory setting x.x
"SIL" submenu
This menu only appears if the device was ordered with the 'SIL mode' option. The SIL
option parameter indicates whether the device can be operated in the SIL mode. To
enable the SIL mode for the device, it is necessary to perform menu-guided operation
for Expert mode.
For more detailed information please refer to the Functional Safety Manual
SD01632T/09.
SIL option
Navigation Setup → Advanced setup → SIL → SIL option
To Next Page
Loading...
