Endress+Hauser iTEMP TMT71 - Page 62

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
Operating menu and parameter description iTEMP TMT71/72
Diagnostics → Min/max values → Sensor min value →  70
Sensor max. value →  70
Reset sensor min/max values →  71
Device temperature min. →  71
Device temperature max. →  71
Reset device temp. min/max values →  71
Application → Measured values → Sensor value →  71
Sensor raw value →  71
Output current →  71
Percent of range →  71
Device temperature →  71
PV →  72
SV →  72
TV →  73
QV →  73
Application → Sensor → Unit →  73
Sensor type →  73
Connection type →  74
2-wire compensation →  74
Reference junction →  74
RJ preset value →  75
Sensor offset →  75
Application → Sensor → Linearization → Call./v. Dusen coeff. R0, A, B, C →  75
Polynomial coeff. R0, A, B →  76
Sensor lower limit →  76
Sensor upper limit →  77
Application → Current output → 4mA value →  77
20mA value →  77
Failure mode →  77
Failure current →  78
Current trimming 4 mA →  79
Current trimming 20 mA →  79
Damping →  79
Application → HART configuration → Assign current output (PV) →  80
Assign SV →  80
Assign TV →  80
Assign QV →  80
62 V. 1, Rev. 2, 4-10-2018 Endress+Hauser