Endress+Hauser iTEMP TMT82 - Access to the Operating Menu via the Operating Tool

iTEMP TMT82 Operating options
Endress+Hauser 27
display is removed. To deactivate the write protection, the device must be restarted with
the display attached and the DIP switch deactivated (WRITE LOCK = OFF).
Turning the display
The display can be rotated 180° using the "DISPL. 180°" DIP switch. The setting is retained
when the display is removed.
6.4 Access to the operating menu via the operating tool
6.4.1 FieldCare
Function scope
FDT/DTM-based plant asset management tool from Endress+Hauser. It can configure all
smart field units in a system and help you manage them. By using the status information,
it is also a simple but effective way of checking their status and condition. Access takes
place via the HART
®
protocol or CDI (= Endress+Hauser Common Data Interface).
Typical functions:
• Configuring parameters of transmitters
• Loading and saving device data (upload/download)
• Documentation of the measuring point
• Visualization of the measured value memory (line recorder) and event logbook
For details, see Operating Instructions BA027S/04/xx and BA059AS/04/xx
NOTICE
For use in hazardous areas: Before accessing the device with the Commubox FXA291
via the CDI (= Endress+Hauser Common Data Interface), disconnect the transmitter
from the power supply, terminals (1+) and (2-).
‣
Failure to comply with this instruction can result in damage to parts of the electronics.
Source for device description files
See data →  30