Endress+Hauser iTEMP TMT84 - Display and Operating Elements

Operation TMT84
22 Endress+Hauser
5.2 Display and operating elements
5.2.1 Display
a0008549
Fig. 11: Optional LC display of the head transmitter
5.2.2 Display symbols
5.2.3 Local operation
You can make hardware settings for the fieldbus interface using miniature switches (DIP switches)
on the rear of the optional display  Page 24.
Item
No.
Function Description
1 Displays the TAG TAG, 32 characters long.
2 'Communication' symbol The communication symbol appears when read and write-
accessing via the fieldbus protocol.
3 Unit display Unit display for the measured value displayed.
4 Measured value display Displays the current measured value.
5 Channel display C1 or C2, P1, S1 or P2, S2, RJ E.g. C1 for a measured value from channel 1. (S = Second-
ary value, P = Primary value; C = Channel, RJ = Reference
junction)
6 'Configuration locked' symbol The 'configuration locked' symbol appears when configura-
tion is locked via the hardware.
7 Warning or error message If a warning occurs, the display alternates between the
measured value and the warning code. If an error occurs,
the display alternates between the error code and
"- - - -" (no valid measured value available), (see chapter
'Status messages’.