TMT84 11 Operation using PROFIBUS
®
PA
Endress + Hauser 53
11 Operation using PROFIBUS
®
PA
The operation is geared towards the user role of the operator in question and groups the operating
parameters into appropriate operating menus.
Two setup modes are available in this user-oriented operating system: The "Standard" setup and the
"Expert" setup.
All the basic settings that are needed to operate the device can be made in the Standard setup mode.
The "Expert" setup is reserved for experienced users or service staff. All the configuration options of
the "Standard" setup are available in the "Expert" setup mode. In addition, additional parameters
make it possible to make special device settings in this mode. Besides these two menu items, the
Display/Operation menus are available for configuring the optional display and the Diagnostics
menu is available for system and diagnostics information.
The device parameters are explained in the following chapter using the user-oriented operating sys-
tem. All the device parameters that are not listed in this operating structure can only be modified
with the aid of appropriate tools and the information in the slot index lists (Chapter 11.4).
11.1 Operating structure
Display/operation Page 54
Advanced setup Page 60
Sensor 1
Setup Page 56 Sensor 2
Security settings
System information Page 63
Diagnostics Page 63 Measured value Page 64 Min./max. values
Device test/reset Page 66
System Page 67 Display
Sensory mechanism Page 69
Sensor 1 Special linearization 1
Sensor 2 Special linearization 2
Communication Page 75
Analog Input 1
Expert Page 67 Analog Input 2
Analog Input 3
Analog Input 4
Diagnostics Page 85
System information
Measured value Min./max. values
Device test/reset
To Next Page
Loading...
