Endress+Hauser iTEMP TMT84 - Page 55

TMT84 11 Operation using PROFIBUS
®
PA
Endress + Hauser 55
n = Number of display channels (1 to 4)
Configuration example:
The following measured values should be shown on the display:
• Value 1:
• Value 2:
• Value 3:
Every measured value should be visible on the display for 12 seconds.
For this purpose, the following settings should be made in the "Display/Operation" operating menu
Display format n read/
write
For selecting the number of places displayed after the dec-
imal point. Configuration option from 0 to 4. The option 4
means 'AUTO'. The maximum number of decimal places
possible always appears on the display.
Possible settings:
– 0 - xxxxx
– 1 - xxxx.x
– 2 - xxx.xx
– 3 - xx.xxx
– 4 - Auto
Factory settings:
1 - xxxx.x
Measured value to be displayed: Primary Value 1
of Sensor Transducer 1 (PV1)
Measured value unit: °C
Decimal places: 2
Measured value to be displayed: RJ Value
Measured value unit: °C
Decimal places: 1
Measured value to be displayed: Sensor Value 2 (measured value) of Sensor Trans-
ducer 2 (SV2)
Unit: °C
Decimal places: 2
Parameter Value
Alternating time 12
Display source 1 ’Primary Value 1’
Display value description 1 TEMP PIPE 11
Display format 1 ’xxx.xx’
Display source 2 ’RJ Value’
Display value description 2 INTERN TEMP
Display format 2 ’xxxx.x’
Display source 3 ’Sensor value 2’
Display value description 3 PIPE 11 BACK
Display format 3 ’xxx.xx’
Display/operation
Menu item Parameter
"Display/opera-
tion"
(Expert-
 System

Display)
Name
Parame-
ter access
Description