Operation Liquiline CM442R/CM444R/CM448R
112 Endress+Hauser
Path: Menu/Setup/Additional functions/Measuring range switch
Function Options Info
MRS set 1
MRS set 2
If you enter both activation codes, you have two
independent parameter sets available for measuring
range switching. The submenus are the same for both
sets.
MRS Options
•On
•Off
Factory setting
Off
Switches the function on or off
Sensor Options
•None
• Connected, inductive
conductivity sensors
Factory setting
None
This function can be used on conductivity sensors only.
Binary input 1 Options
•None
• Binary inputs
• Fieldbus signals
• Limit switch
Factory setting
None
Source of the switching signal, can be selected for input
1 and 2 in each case
Binary input 2
Sensor = conductivity sensor
Measuring range 00
Measuring range 01
Measuring range 10
Measuring range 11
Select the MRSs; a maximum of 4 are possible.
The submenus are identical for each and thus are
displayed only once.
Operating mode Options
• Conductivity
• Concentration
Factory setting
Conductivity
To Next Page
Loading...
