Installation Liquiline CM442/CM444/CM448
18 Endress+Hauser
5.2.3 Wall mounting
Mount the controller in such a way that the wall support surface is the size of the rear housing
panel at the very least.
a0012686
Fig. 15: Mounting distance in mm (inch)
a0012684
Fig. 16: Wall mounting
1Wall
2 4 drill holes
1)
3Mounting plate
4 Screws Ø 6 mm (not part of
scope of supply)
1) The size of the drill holes depends on the dowels used. The dowels and screws must be provided by the customer.
a0012685
Fig. 17: Attach the device and click it into
place
To Next Page
Loading...
