Liquiline CM44P Electrical connection
Endress+Hauser 25
2. Remove the dummy plug.
3. Attach the gland to the cable end, making sure the gland is facing the right direction.
4. Pull the cable through the gland and into the housing.
5. Route the cable in the housing in such a way that the exposed cable shield fits into one
of the cable clamps and the cable cores can be easily routed as far as the connection plug
on the electronics module.
6. Connect the cable to the cable clamp.
7. Clamp the cable.
8. Connect cable cores as per the wiring diagram.
9. Tighten the cable gland from outside.
5.1.4 Cable terminals
Plug-in terminals for Memosens and PROFIBUS/RS485 connections
‣
Press the screwdriver against the
clip (opens the terminal).
‣
Insert the cable until the limit stop.
‣
Remove the screwdriver (closes the
terminal).
After connection, make sure that every cable end is securely in place. Terminated cable
ends, in particular, tend to come loose easily if they have not been correctly inserted as
far as the limit stop.
To Next Page
Loading...
