Operation Liquiline CM44P
102 Endress+Hauser
Source of data Measured value
ISE Selection
• Temperature
• pH
• Ammonium
• Nitrate
• Potassium
• Chloride
TU/TS Selection
• Temperature
• Turbidity g/l
(only TU/TS)
• Turbidity FNU
(only TU/TS)
• Turbidity Formazine
(only TU)
• Turbidity solid
(only TU)
TU
Nitrate Selection
• Temperature
• NO3
• NO3-N
Ultrasonic interface Selection
• Temperature
• Interface
• Turbidity
SAC Selection
• Temperature
• SAC
• Transm.
• Absorption
• COD
• BOD
Controller 1 Selection
• Bipolar
(only for current outputs)
• Unipolar+
• Unipolar-
Controller 2
Mathematical functions All the mathematical functions can also be used as a data source and the calculated
value can be used as the measured value.
You can monitor the manipulated variable by assigning the controller manipulated
variable to a limit switch (e. g. configure a dosing time alarm).
Menu/Setup/Additional functions/Limit switches/Limit switch 1 ... 8
Function Options Info
Cleaning program Selection
• None
• Cleaning 1 ... 4
Factory setting
None
Use this function to choose which cleaning
instance should start when the limit switch is
active.
Function Selection
• Off
• On
Factory setting
Off
Activating/deactivating the limit switch
To Next Page
Loading...
