Diagnostics, troubleshooting CM42-MAA101EBE00
30 Endress+Hauser
• Operating time
Sensor operation, e.g. total operating time and operation under extreme conditions
• Max. operating values
Maximum and minimum measured values
3.15 Firmware history
Date Version Changes in the firmware Documentation: edition
05/2014 02.01.00 Improvement
• Support for new bus module FBPA3, FBPA1 is no longer
supported
• Refactored bus drivers (DTM/DD) with full operation
• Revised menus
• Revised sensor information
• Possible to change sensor type without DAT
• Sensor status: all status values and operating hours values
are displayed numerically
BA00381C/07/XX/15.14
BA00382C/07/XX/15.14
04/2012 Package
07 to 13
Extension
• Support for pH/ORP combined sensors
Improvement
• Enhanced user administration
• Damping can be set for up to 600 s
• Alarm and warning signal possible at both current outputs
• Current output allows negative measuring range slope
(lower limit > upper limit)
• Choice of measured variables modified
• Modified configuration of diagnostics messages
• Modified diagnostics messages
BA00381C/07/XX/14.12
BA00382C/07/XX/14.12
11/2010 Package
06
Extension
• Support for Korean
Improvement
• Sensor state display
• Sensor check
BA00381C/07/XX/13.10
BA00382C/07/XX/13.10
11/2009 Package
05
Extension
• Manual hold also in the "Basic" software version
Improvement
• Two-point calibration for special buffers corrected
• Improved table entry
BA00381C/07/XX/03.10
BA00382C/07/XX/03.10
10/2008 10.05.00 Extension
• User administration upgraded
• Monitoring functions
• DAT functionalities: Upgrade, update, saving user settings by
DAT
• Redesign of measuring menus
• HART protocol 6
BA00381C/07/XX/08.08
BA00382C/07/XX/08.08.
02/2008 10.04.05 Improvement
• 3.6 mA functionality
BA00381C/07/XX/02.08
BA00382C/07/XX/02.08
05/2007 10.04.05 Extension
• Memobase functions
BA00381C/07/XX/05.07
BA00382C/07/XX/05.07
To Next Page
Loading...
