Endress+Hauser Liquistation CSF34 - Page 155

Liquistation CSF34 Diagnostics and troubleshooting
Endress+Hauser 155
No. Message Factory settings Tests or remedial action
S
1)
D
2)
F
3)
375 No 4R module F On On No connection to the 4R module
1. Check the 4R module, replace it if
necessary.
2. Restart the software under: Menu/
Diagnostics/Device restart.
401 Factory reset F On On Factory reset is performed
403 Device verification M Off Off Device verification active, please wait
405 Service IP active C Off Off Endress+Hauser Service switch is switched on
The device can be addressed at 192.168.1.212.
‣
Switch off the service switch to change to the
saved IP settings.
412 Writing backup F On Off
‣
Wait for the write process to be finished
413 Reading backup F On Off
‣
Wait.
455 Mathemat. function F On On Mathematical function: fault condition
1. Check mathematical function.
2. Check assigned input variables.
460 Output below limit S On Off Reasons
• Sensor in air
• Air pockets in assembly
• Sensor fouled
• Incorrect flow to sensor
1. Check sensor installation.
2. Clean sensor.
3. Change assignment of current outputs.
461 Output above limit S On Off
502 No text catalog F On On
‣
Contact Endress+Hauser Service.
503 Language change M On Off Language change failed
‣
Contact Endress+Hauser Service.
529 Diag. setup active C Off Off
‣
Wait for maintenance to be finished.
530 Logbook at 80% M On Off 1. Save the logbook to the SD card and then
delete the logbook in the device.
2. Set memory to circular buffer.
3. Deactivate logbook.
531 Logbook full M On Off
532 License error M On Off
‣
Contact Endress+Hauser Service.
536 SD card (80%) M On Off SD card 80% full
1. Replace SD card with empty card.
2. Clear SD card.
3. Set logbook properties to ring buffer under
Logbooks.
537 SD card (100%) M On Off SD card 100% full. No longer possible to write to
the card.
1. Replace SD card with empty card.
2. Clear SD card.
3. Set logbook properties to ring buffer under
Logbooks.
538 SD card removed M On Off SD card not plugged in
1. Check SD card.
2. Replace SD card.
3. Disable logging.