Inputs: General Liquistation CSF48
108
9Inputs: General
9.1 Configuration
An input can be configured in one of two ways:
1. Configuration where a sensor is not connected
‣ Select the appropriate channel.
‣ From the list of sensor types, select the sensor which you want to configure.
‣ Configure the channel as explained in following sections.
‣ Connect the selected sensor type later on.
2. Configuration where a sensor is connected
‣ Configure the channel as explained in following sections.
The following applies when configuring without a sensor:
• Some settings require sensor communication.
You cannot make these settings if a sensor is not connected.
• It is also possible to save a setup and transfer it to another device (see "Data management" in
the "General settings" section). This function might be a better option than performing a con-
figuration when a sensor is not connected.
9.2 Frequently occurring functions
Some submenus are identical for all sensor types.
These submenus are explained below so you can find a description of these menus at one central
place. Instead of repeating the description, the sensor-specific section then only contains a refe-
rence to this chapter.
9.2.1 Damping
The damping causes a floating average curve of the measured values over the time specified.
Path: Menu/Setup/Inputs/<Sensor type>
Function Options Info
Damping <Sensor type> 0 to 600 s
Factory setting
0 s
You specify the damping of the main measured value of
the connected sensor and that of the integrated
temperature sensor.
Damping temp.
To Next Page
Loading...
