Endress+Hauser Liquistation CSF48 - Page 109

Liquistation CSF48 Inputs: General
109
9.2.2 Manual hold
9.2.3 Cleaning
9.2.4 Calibration timer and calibration expiration date
You can specify the calibration interval for the sensor here.
Once the time configured elapses, the "Calibration timer" diagnostics message appears on the
display.
The timer is reset automatically if you recalibrate the sensor.
Path: Menu/Setup/Inputs/<Sensor type>
Function Options Info
Manual hold Options
•On
•Off
Factory setting
Off
On
You can use this function to set the channel manually to
"Hold".
Off
No hold
Path: Menu/Setup/Inputs/<Sensor type>/Extended setup
Function Options Info
Cleaning Options
•None
• Cleaning 1
• Cleaning 2
• Cleaning 3
• Cleaning 4
Factory setting
None
Select a cleaning program.
This program is executed:
• In a specified interval
To do so, the cleaning program must be started.
• If a diagnostic message is pending on the channel
and a cleaning has been specified for this message
(--> "Inputs/Diagnostics settings/Diag. behavior").
You define the cleaning programs in the "Setup/Additional functions/Cleaning" menu.
Path: Menu/Setup/Inputs/<Sensor type>/Extended setup/Calib. settings
Function Options Info
Calibration timer Options
•Off
•On
Factory setting
Off
Switches the function on or off