Endress+Hauser Liquistation CSF48 - Page 136

Inputs: Oxygen Liquistation CSF48
136
12.2.2 Measured value formats
12.2.3 Medium compensation (in the process)
Path: Menu/Setup/Inputs/DO or Chlorine/Extended setup
1)
1) In the case of chlorine, the sequence of the two menu functions is reversed
Function Options Info
Main value format Options
•#.#
•#.##
• #.###
•#
Factory setting
#.##
Specify the number of decimal places for displaying the
main measured value.
Temperature format Options
•#.#
•#.##
Factory setting
#.#
Select how many decimal places should be used to
display the temperature.
Path: Menu/Setup/Inputs/DO/Extended setup
Function Options Info
Medium pressure Options
• Process pressure
• Air pressure
• Altitude
Factory setting
Air pressure
Altitude
Medium pressure="Altitude"
-300 to 4000 m
Factory setting
0 m
Enter the altitude or the average air pressure (mutually
dependent values).
If you specify the altitude, the average air pressure is
calculated from the barometric altitude formula and vice
versa.
If you are compensating using the process pressure,
enter the pressure in your process here. The pressure is
then independent of the altitude.
Air pressureorProcess
pressure
Medium pressure="Air pres-
sure"
500 to 1200 hPa
Medium pressure="Process
pressure"
500 to 9999 hPa
Factory setting
1013 hPa
Salinity 0 to 40 g/kg
Factory setting
0 g/kg
The influence of salt content on oxygen measurement is
compensated with this function. Example: sea water
measurement as per Copenhagen Standard (30 g/kg).