General settings Liquistation CSF48
22
2.6.6 Data management
Firmware update
Please contact your local sales office for information on firmware updates available for your con-
troller and its compatibility with earlier versions.
Your current firmware version can be found at: Menu/Diagnostics/System information/Soft-
ware version.
First save your current setup on an SD card since a firmware update overwrites your set-
tings with the factory settings. After updating the firmware, you can restore your setup by
uploading it from the SD card.
To install a firmware update, you must have the update available on an SD card.
1. Insert the SD card into the controller card reader.
2. Go to: Menu/Setup/General settings/Extended setup/Data management/Firmware
update.
--> The update files on the SD card are displayed.
3. Select the desired update and select yes when the following question is displayed: The cur-
rent firmware will be overwritten. After this the device will reboot. Do you want to pro-
ceed?
--> The firmware is loaded and the device is then started with the new firmware.
Saving the setup
Saving the setup gives you the following advantages:
• Quick and easy to restore a setup following a firmware update
• Copying settings for other devices
• Quick and easy switching between various setups, e.g. for different user groups or for
recurring sensor type change
• Restoring a tried-and-tested setup, e.g. if you have changed a lot of settings and no longer
know what the original settings were
1. Insert the SD card into the controller card reader.
2. Go to: Menu/Setup/General settings/Extended setup/Data management/Save setup.
3. Assign a file name (Name).
4. Then select "Save".
5. If you have already assigned the file name, you will be asked whether you want to
overwrite the existing setup.
Select "OK" to confirm, or cancel the action and give the file a new name.
--> Your setup is stored on the SD card and you can upload it quickly to the device at a later date.
Loading the setup
You can load a setup you have saved quickly and easily:
1. Insert the SD card into the controller card reader.
2. Go to: Menu/Setup/General settings/Extended setup/Data management/Load setup.
--> A list of all the setups on the SD card is displayed.
To Next Page
Loading...
