Liquistation CSF48 General settings
23
3. Select the desired setup.
The device then displays the following message:The current parameters will be overwrit-
ten and the device will reboot. Warning: Please note that cleaning and controller programs
can be active. Do you want to proceed?
4. Select "OK" to confirm or cancel the action.
--> The desired setup is restored after restarting the device.
Exporting the setup
Exporting the setup gives you the following advantages
•Export in xml format
• Import the data e.g. into MS Excel (drag&drop the xml file in an open Excel window)
1. Insert the SD card into the controller card reader.
2. Go to: Menu/Setup/General settings/Extended setup/Data management/Export setup.
3. Assign a file name (Name).
4. Then select "Export".
5. If you have already assigned the file name, you will be asked whether you want to
overwrite the existing setup.
Select "OK" to confirm, or cancel the action and give the file a new name.
--> Your setup is saved on the SD card.
Activation code
You require activation codes for:
• Additional functions, e.g. fieldbus communication
• Software upgrades
Enter the activation code:
‣ Menu/Setup/General settings/Extended setup/Data management/Activation code.
‣ Confirm your entry. Your new hardware or software function is then activated and can be
configured.
If activation codes are available for your device, these codes are provided on the inner
nameplate. The corresponding device functions are activated at the factory. You only
require the codes if servicing the device.
The table below tells you what functions an activation code enables:
Function Activation code beginning with
Second Memosens input 062...
Two current outputs (BASE-E module only) 081...
HART 0B1...
PROFIBUS DP 0B3...
Modbus TCP 0B4...
Modbus RS485 0B5...
To Next Page
Loading...
