Endress+Hauser Liquistation CSF48 - Page 59

Liquistation CSF48 Programming
59
The settings that depend on the sampling mode are listed in the "Program type: Basic" section.
Enable subprogram Options
•Immediate
• Individual dates
• Repeating date
•Interval
• Deactivation
Factory setting
Immediate
Immediate:
The subprogram is enabled immediately.
Individual dates:
Set the start and stop dates for enabling the subpro-
gram.
Repeating date:
Set the start condition, activity time and repetition
interval for the subprogram.
Interval:
Set the start condition, activity time and inactivity
time for the subprogram.
Deactivation:
Only visible if there is more than one subprogram
If Enable subprogram Individual dates is selected:
Individual dates
Set the start and stop times for the subprogram. Enter a new date via "INSERT". Delete a date via "DELETE". You can
assign a maximum of 25 start and stop dates.
If Enable subprogram Repeating date is selected:
Start condition Options
•No delay
• Date/Time
•Time
Factory setting
No delay
No delay:
The subprogram is started when the program is enab-
led.
Date/Time:
Set the start date and start time for enabling the sub-
program.
Time:
Set the start time for enabling the subprogram.
Activity time 00:01 to 99:59 HH:MM
Factory setting
00:01 HH:MM
Specify how long the subprogram should be active in
hours and minutes.
The time to be selected depends on the setting for the
repetition mode.
Multiple date
Repetition mode Options
• Daily interval
•Weekly interval
•Days of week
Factory setting
Daily interval
Daily interval:
Specify whether the subprogram should be repeated
every day.
Weekly interval:
Specify whether the subprogram should be repeated
every week.
Days of week:
Specify whether the subprogram should be repeated
on certain days of the week.
--> Select the days of the week in the subsequent
menu item.
Path: Menu/Setup/Sampling programs
Function Options Info