Endress+Hauser Liquistation CSF48 - Page 90

Operation Liquistation CSF48
90 Endress+Hauser
EtherNet/IP
EtherNet Industrial Protocol is an open fieldbus standard of the Open DeviceNet Vendor
Association (ODVA). --> www.odva.org
Watchdog 0 to 999 s
Factory setting
5 s
If no data transmission takes place for longer than the
time set, this is an indicator that communication has
been interrupted.
After this time, input values received via the Modbus are
considered to be invalid.
Path: Menu/Setup/General settings/Extended setup/Ethernet
Function Options Info
Enable Options
•Off
•On
Factory setting
On
You can switch ethernet communication on and off at
this point.
Settings
Link settings Options
•Auto negotiation
• 10MBps Half duplex
• 10MBps Full duplex
• 100MBps Half duplex
• 100MBps Full duplex
Factory setting
Auto negotiation
Transmission methods of the communication channels
• Full duplex:
Data can be transmitted simultaneously in both
directions.
•Half-duplex:
Data can only be transmitted alternately in both
directions, i.e. not at the same time.
Source: Wikipedia
DHCP Options
•Off
•On
Factory setting
Off
The Dynamic Host Configuration Protocol (DHCP) makes
it possible to assign the network configuration to clients
via a server. With DHCP, it is possible to automatically
integrate the device into an existing network without
the need for manual configuration. Normally, the client
need only be configured for automatic retrieval of the IP
addresses. During startup, the IP address, the netmask
and the gateway are retrieved from a DHCP server.
IP-Address xxx.xxx.xxx.xxx
Factory setting
192.168.1.212
An IP address is an address in computer networks which
are based on the Internet protocol (IP).
Netmask xxx.xxx.xxx.xxx
Factory setting
255.255.255.0
On the basis of the IP address of a device, the netmask
specifies which IP addresses this device searches for in
its own network and which addresses it could access in
other networks via a router. It therefore divides the IP
address into a network part (network prefix) and a
device part. The network part must be identical for all
devices in the individual network, and the device part
must be different for every device within the network.
Path: Menu/Setup/General settings/Extended setup/Modbus
Function Options Info