Endress+Hauser Micropilot FMR60 - Process; Process Temperature, Process Pressure

DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT
Micropilot FMR60
32 V. 4, Rev. 2, 19-03-2018 Endress+Hauser
Process
Process temperature, process
pressure
The pressure ranges indicated can be reduced by the choice of process connection. The nominal
pressure (PN) indicated on the nameplate refers to a reference temperature of 20 °C, and of
100 °F for ASME flanges. Observe pressure-temperature dependency.
Please refer to the following standards for the pressure values permitted at higher
temperatures:
• EN 1092-1: 2001 Tab. 18
In terms of their stability-temperature property, the materials 1.4435 and 1.4404 are
grouped in EN 1092-1 table 18 under 13E0. The chemical composition of the two materials
can be identical.
• ASME B 16.5a – 1998 Tab. 2-2.2 F316
• ASME B 16.5a – 1998 Tab. 2.3.8 N10276
• JIS B 2220
FMR60 threaded process connection
p
-40
(-40)
+130
(+266)
0
(+32)
T
p
[°C]
([°F])
1
[bar] ([psi])
16 (232)
-1 (-14.5)
0 (0)
A0032614
 10 FMR60: Permitted range for process temperature and process pressure
1 Feature 90, seal: A4, FKM Viton GLT
FMR60 threaded process connection
Feature 100 "Process
connection"
Feature 90
"Seal"
Process temperature
range
Process pressure range
• GGJ:
Thread ISO228 G1-1/2
• RGJ:
Thread ANSI MNPT1-1/2
A4:
FKM Viton GLT
–40 to +130 °C
(–40 to +266 °F)
p
rel
=
–1 to 16 bar
(–14.5 to 232 psi)
1)
1) The pressure range may be further restricted in the event of a CRN approval