Endress+Hauser Micropilot FMR67B - Changing the Installation Position of the Display Module

Mounting Micropilot FMR67B PROFINET with Ethernet-APL
22 Endress+Hauser
5.3.9 Changing the installation position of the display module
The installation position of the display can be changed in the case of the dual
compartment housing, L-form.
A0048401
L
WARNING
Supply voltage switched on!
Risk of electric shock and/or explosion!
‣
Switch off the supply voltage before opening the measuring device.
1 → 2 → 3 →
0.7 Nm
4 mm
2 x
1.
2.
2.
1.
A0046831 A0046832 A0046833
‣
If fitted: release the screw of
the cover lock for the display
cover using the Allen key.
‣
Unscrew the display cover and
check the cover seal.
‣
Press the release mechanism,
remove the display module.
4 → 5 → 6 →
0.7 Nm
4 mm
2 x
1.
2.
A0046834 A0046923 A0046924
‣
Release the connection.
‣
If fitted: release the screw of
the cover lock for the
connection compartment cover
using the Allen key.
‣
Unscrew the connection
compartment cover, check the
cover seal. Screw this cover
onto the electronics
compartment instead of the
display cover. If fitted: tighten
the screw of the cover lock
using the Allen key