Incoming acceptance and product identification Nivotester FTL325P single-channel
6 Endress+Hauser
2.5 Product safety
This device has been constructed and tested to state-of-the-art operational safety standards
and in accordance with good engineering practice. The device left the factory in a safe
operating condition.
2.5.1 CE mark
The device meets the legal requirements of the applicable EU Directives. These are listed in
the corresponding EU Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
2.5.2 EAC conformity
The device meets the legal requirements of the applicable EAC Directives. These are listed in
the corresponding EAC Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the EAC mark.
3 Incoming acceptance and product identification
3.1 Incoming acceptance
Check the following during goods acceptance:
Are the order codes on the delivery note and the product sticker identical?
Are the goods undamaged?
Do the nameplate data match the ordering information on the delivery note?
If necessary (see nameplate), are the Safety Instructions, e. g. XA, provided?
If one of these conditions is not satisfied, contact your Sales Center.
3.2 Product identification
Nameplate data on the device
‣
Enter the serial number from the nameplates in the W@M Device Viewer
(www.endress.com/deviceviewer)
All the information about the measuring device and all associated Technical
Documentation are displayed.
‣
Enter the serial number from the nameplate in the Endress+Hauser Operations app.
All the information about the measuring device and all associated Technical
Documentation are displayed.
To Next Page
Loading...
