6.5 Repairs
Should the Prolevel FMC 661 transmitter or its sensor need to be repaired by
Endress+Hauser, please send it to your nearest Service Centre with a note containing
the following information:
• An exact description of the application for which it was used.
• The physical and chemical properties of the product measured.
• A short description of the fault.
Caution!
• Special precautions must be observed when sending probes for repair:
• Remove all visible traces of product from the probe.
• If the product can impair health, i.e. is corrosive, poisonous, carcinogenic,
radioactive etc., please check that the probe is thoroughly decontaminated.
• If the last traces of dangerous products cannot be removed, e.g. product has
penetrated into fissures or diffused into plastic parts, we kindly ask you not to
send the probe for repair.
Caution!
Prolevel FMC 661 Chapter 6: Trouble-Shooting
Endress+Hauser 45
To Next Page
Loading...
