Endress+Hauser Proline 200 - Page 29

Flowmeter Proline 200 PROFINET with Ethernet-APL Electrical connection
Endress+Hauser 29
8 mm
TX 10
4.
5.
A0034174
4. Loosen the locking screw of the transmitter housing.
5. Loosen the securing clamp of the transmitter housing.
~15°
6.
7.
A0034175
 6 Sample graphic
6. Turn the transmitter housing to the right until it reaches the marking.
7.
NOTICE
The connection board of the wall housing is connected to the electronics board of
the transmitter via a signal cable!
‣
Pay attention to the signal cable when lifting the transmitter housing!
Lift the transmitter housing.