Endress+Hauser Proline 200 - 8.5 Protecting settings from unauthorized access; 8.6 Application-specific commissioning; 8.6.1 Steam application

Commissioning Flowmeter Proline 200 PROFINET with Ethernet-APL
40 Endress+Hauser
The desired units can be selected in the System units submenu. The wizards systematically
guide the user through all the parameters required for configuration, such as parameters for
measurement or outputs.
The wizards available in the particular device can vary on account of the device version
(e.g. sensor).
Wizard Meaning
System units Configure the units for all measured variables
Medium selection Definition of the medium
Display Configuration of the measured value display
Low flow cut off Configuration of the low flow cut off
Advanced setup Additional parameters for configuration:
• Medium properties
• External compensation
• Sensor adjustment
• Totalizer 1 to n
• Heartbeat
• Configuration backup display
• Administration
8.5 Protecting settings from unauthorized access
The following write protection options exist in order to protect the configuration of the
measuring device from unintentional modification:
• Protect access to parameters via access code
• Protect access to local operation via key locking
• Protect access to measuring device via write protection switch
For detailed information on protecting the settings against unauthorized access, see the
Operating Instructions for the device.
8.6 Application-specific commissioning
8.6.1 Steam application
Select medium
Navigation:
Setup → Medium selection
1. Open the Medium selection wizard.
2. In the Select medium parameter, select the Steam option.