Endress+Hauser Proline Promag 10 - Installing the Transmitter Housing

Installation Proline Promag 10
32 Endress+Hauser
2.8 Installing the transmitter housing
2.8.1 Turning the transmitter housing
Turning the aluminum field housing
Aluminum field housing for non-Ex area
2.8.2 Turning the onsite display
2.8.3 Mounting the transmitter (remote version)
The transmitter can be mounted in the following ways:
• Wall mounting
•Pipe mounting
The transmitter and the sensor must be mounted separate in the following circumstances:
• Poor accessibility
• Lack of space
• Extreme fluid/ambient temperatures
• Severe vibration (>2 g/2 h per day; 10 to 100 Hz)
A0008982
A0003237
a. Unscrew cover of the electronics compartment
from the transmitter housing.
b. Remove the display module from the
transmitter retaining rails.
c. Turn the display to the desired position (max.
4 × 45° in each direction).
d. Fit the display back onto the retaining rails.
e. Screw the cover of the electronics compartment
firmly back onto the transmitter housing.
Esc
E
- +
Esc
E
- +
c
e
f
a
b
180° 180°
££
d
4 x 45°