PROline Promag 10 6 Commissioning
Endress+Hauser 61
6.2.2 Brief “commissioning” guide
These brief instructions guide you systematically through the setup procedure for all the
major device functions that have to be configured for standard measuring operation.
Configure display
Display language → Page 94
Display contrast → Page 95
Number of decimal
places
→ Page 95
▼
Select engineering units
Volume flow → Page 93
Totalizer → Page 93
▼
Configure outputs
Current output Pulse/status output
Current span → Page 97 Operating mode → Page 99
Full scale value → Page 98 Pulse value → Page 99
Pulse width → Page 100
or
Assign status output → Page 101
Switch-on point → Page 101
▼
More complex applications
require other functions be programmed. Notes on this can be found on the following
pages:
Functions at a glance → Page 92
Index → Page 119
Operating matrix → Page 92
▼
For optimum measurement results
Low flow cut off → Page 106
Empty pipe detection → Page 107
To Next Page
Loading...
