Endress+Hauser Proline Promag 10 - Page 85

PROline Promag 10 10 Technical data
Endress+Hauser 85
Material Promag W
Transmitter housing:
• Compact housing: powder-coated die-cast aluminum
• Remote version housing: powder-coated die-cast aluminium
Sensor housing:
• DN 25...300: powder-coated die-cast aluminium
• DN 350...600: coated steel (Amerlock 400)
Measuring tube:
• DN < 350: stainless steel 1.4301/304 or 1.4306/304L; flange material with
Al/Zn protective coating
• DN > 300: stainless steel 1.4301/304; flange material with Amerlock 400 coating
Flanges:
• DIN: ST37 / FE 410W B (DN < 350: with Al/Zn protective coating; DN > 300 with
Amerlock 400 coating)
• ANSI: A 105 (DN < 350 with Al/Zn protective coating, DN > 300 with Amerlock 400
coating)
• JIS: S20C (DN < 350 with Al/Zn protective coating, DN > 300 with Amerlock 400
coating)
Ground disks: 1.4435/316L or Alloy C-22
Electrodes: 1.4435/316L, Alloy C-22
Seals: seals to DIN 2690
Promag P
Transmitter housing:
• Compact housing: powder-coated die-cast aluminum
• Remote version housing: powder-coated die-cast aluminium
Sensor housing:
DN 25...300: powder-coated die-cast aluminium
Measuring tube:
Stainless steel 1.4301/304 or 1.4306/304L; flange material with Al/Zn protective coating
Flanges:
• DIN: ST37 / FE 410W B (with Al/Zn protective coating)
• ANSI: A105 (with Al/Zn protective coating)
• JIS: S20C (with Al/Zn protective coating)
Ground disks: 1.4435/316L or Alloy C-22
Electrodes: 1.4435/316L, Alloy C-22
Seal: seals to DIN 2690