PROline Promag 50 10 Technical data
Endress+Hauser 119
Promag H:
• 3A authorization and EHEDG-tested
• Seals in conformity with FDA (except Kalrez seals)
Pressure Equipment
Directive
Measuring devices with a nominal diameter smaller than or equal to DN 25 correspond
to Article 3(3) of the EC Directive 97/23/EC (Pressure Equipment Directive) and have
been designed and manufactured according to good engineering practice. Where
necessary (depending on the medium and process pressure), there are additional
optional approvals to Category II/III for larger nominal diameters.
CE mark The measuring system is in conformity with the statutory requirements of the
EC Directives. Endress+Hauser confirms successful testing of the device by affixing to
it the CE mark.
Other standards and
guidelines
EN 60529
Degrees of protection by housing (IP code)
EN 61010
Protection Measures for Electrical Equipment for Measurement, Control,
Regulation and Laboratory Procedures
EN 61326/A1 (IEC 1326)
Electromagnetic compatibility (EMC requirements)
NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control
equipment.
NAMUR NE 43
Standardisation of the signal level for the breakdown information of digital transmitters
with analogue output signal.
10.1.11 Ordering information
The E+H service organisation can provide detailed ordering information and information
on specific order codes on request.
10.1.12 Accessories
Various accessories, which can be ordered separately from E+H, are available for the
transmitter and the sensor (see Page 85). The E+H service organisation can provide
detailed information on request.
10.1.13 Supplementary documentation
• System Information Promag (SI 028D/06/en)
• Technical Information Promag 50/53 W (TI 046D/06/en)
• Technical Information Promag 50/53 P (TI 047D/06/en)
• Technical Information Promag 50/53 H (TI 048D/06/en)
• Description of Device Functions Promag 50 (BA 049D/06/en)
• Supplementary documentation on Ex-ratings: ATEX, FM, CSA, etc.
To Next Page
Loading...
