PROline Promag 53 3 Installation
Endress+Hauser 15
3.2 Instal lati on condi ti ons
3.2.1 Dimensions
Dimensions and the fitting lengths of the transmitter and sensor are on Page 136 on.
3.2.2 Mounting location
Correct measuring is possible only if the pipe is full. Avoid the following locations:
• Highest point of a pipeline. Risk of air accumulating
• Directly upstream a free pipe outlet in a vertical pipeline.
Fig. 5: Location
Installation of pumps
Do not install the sensor on the intake side of a pump. This precaution is to avoid low
pressure and the consequent risk of damage to the lining of the measuring tube. Infor-
mation on the lining's resistance to partial vacuum can be found on → Page 127.
It might be necessary to install pulse dampers in systems incorporating reciprocating,
diaphragm or peristaltic pumps. Information on the measuring system's resistance to
vibration and shock can be found on → Page 124.
Fig. 6: Installation of pumps
F06-5xxxxxxx-11-00-00-xx-000
F06-5xxxxxxx-11-00-00-xx-001
To Next Page
Loading...
