Endress+Hauser PROline promag 53 - Page 2

Brief operating instructions PROline Promag 53
2 Endress+Hauser
Brief operating instructions
These brief operating instructions show you how to configure the measuring device
quickly and easily:
Safety instructions Page 7
▼
Installation Page 13
▼
Wiring Page 47
▼
Switching on the measuring device Page 83
▼
Display and operating elements Page 61
▼
Commissioning with “QUICK SETUP” Page 84 ff.
You can commission the measuring device quickly and easily, using the special
“Quick Setup” menu. It enables you to configure important basic functions using
the local display, for example display language, measured variables, units
engineering, type of signal, etc.
The following adjustments can be made separately as necessary:
– Empty-pipe/full-pipe calibration for empty pipe detection (EPD)
– Configuration of relay contacts (NC or NO contact)
– Configuration of current outputs (active/passive), etc.
▼
Application-specific QUICK SETUPs Page 85 ff.
In “Quick Setup” mode you have the option of launching other, application-
specific Quick Setups, for instance the menu for measuring pulsating flow.
▼
Customer-specific configuration Page 65 ff.
Complex measuring operations necessitate additional functions that you can
configure as necessary with the aid of the function matrix, and customize to suit
the process parameters.
All functions are described in detail, as is the function matrix itself, in the
“Description of Device Functions” manual, which is a separate part of this
Operating Instruction.
▼
▼
Troubleshooting / Remedy Page 99 ff.
Always start troubleshooting with the checklist on Page 99, if faults occur after
commissioning or during operation. The routine takes you directly to the cause of
the problem and the appropriate remedial measures.
Returning devices
If you return a measuring device to Endress+Hauser for repair or calibration,
you must obtain a Return Authorization number. See Return Authorization Policy
at the back of this manual.