3 Installation PROline Promag 53
44 Endress+Hauser
Panel installation
1. Prepare the opening in the panel (Fig. 26).
2. Slide the housing into the opening in the panel from the front.
3. Screw the fasteners onto the wall-mount housing.
4. Place the threaded rods in the fasteners and screw them down until the housing is
seated tightly against the panel. Afterwards, tighten the locking nuts. Additional
support is not necessary.
Fig. 26: Panel Installation (wall-mount housing)
Pipe mounting
The assembly should be performed by following the instructions in Fig. 27.
"
Caution:
If the device is mounted to a warm pipe, make certain that the housing temperature
does not exceed 140 °F (60 °C), which is the maximum permissible temperature.
Fig. 27: Pipe mounting (wall-mount housing)
F06-xxxxxxxx-06-03-06-xx-002
Dimensions in inches (mm)
F06-xxxxxxxx-06-03-06-xx-001
Dimensions in inches (mm)
To Next Page
Loading...
