Endress+Hauser PROline promag 53 - 4.2 Connecting the Remote Version

4 Wiring PROline Promag 53
50 Endress+Hauser
Cable termination for the remote version
Promag H
Terminate the signal and coil current cables as shown in the figure below (Detail A).
Fit the fine-wire cores with cable end sleeves (Detail B).
" Caution!
When fitting the connectors, pay attention to the following points:
• Signal cable
→ Make sure that the cable end sleeves do not touch the wire shield on the sensor side.
Minimum distance = 0.04"/1 mm (exception “GND” = green cable).
• Coil current cable
→ Insulate one core of the three-core wire at the level of the core reinforcement; you only require two cores for the
connection.
• On the sensor side, reverse both cable shields approx. 0.59" (15 mm) over the outer jacket. The strain relief ensures an electrical connec-
tion with the connection housing.
TRANSMITTER
Signal cable Coil current cable
SENSOR
Signal cable Coil current cable
F06-5xxxxxxx-04-11-08-ae-000
Dimensions in inches (mm)
F06-5xxxxxxx-04-11-08-xx-000ae
Dimensions in inches (mm)
F06-5xHxxxxx-04-11-08-ae-000
Dimensions in inches (mm)
F06-5xHxxxxx-04-11-08-xx-000ae
Dimensions in inches (mm)