Endress+Hauser PROline promag 53 - 4.5 Degree of Protection

5Operation PROline Promag 53
64 Endress+Hauser
Controlling the batching processes using the local display
With measuring instruments with suitable software, you can carry out batching proc-
esses directly using the local display. Therefore, the Promag 53 can be fully deployed
in the field as a “batch controller”.
Procedure:
1. Configure all the required batching functions and assign the lower display info line
(= BATCHING KEYS) using the “Batch” Quick Setup menu or use the function
matrix. The following “softkeys” then appear on the bottom line of the local display
(Fig. 43):
– START = left display key (–)
– PRESET = middle display key (+)
– MATRIX = right display key (E)
2. Press the “PRESET (+)” key. Various batching process functions requiring configu-
ration will now appear on the display:
3. After exiting the PRESET menu, you can now start the batching process by press-
ing “START (–)”. New softkeys (STOP / HOLD or GO ON) now appear on the display.
You can use these to interrupt, continue or stop the batching process at any time
(Fig. 43):
STOP (–) → Stop batching process
HOLD (+) → Interrupts batching process (softkey changes to “GO ON”)
GO ON (+) → Continues batching process (softkey changes to “HOLD”)
After the batch quantity is reached, the “START” or “PRESET” softkeys reappear on
the display.
Fig. 43: Controlling batching processes using the local display (softkeys)
“PRESET” → Initial settings for the batching process
No. Function Settings
7200 BATCH SELECTOR
OS → Selection of the batching liquid
(BATCH #1...6)
7203 BATCH QUANTITY Displays the appropriate batching quantity (changes are
only possible after entering the enabling code).
7265 RESET TOTAL
BATCH SUM/COUNTER
Resets the batching quantity counter or the total batching
quantity to “0”.
STOP GO ON MATRIX
+2.5 l
0.0 l
E
+2.5 l
0.0 l
0.0 l
+
-
+2.5 l
0.0 l
START
PRESET MATRIX
STOP HOLD MATRIX
F06-x3xxxxxx-07-xx-xx-xx-005