PROline Promag 53 5Operation
Endress+Hauser 77
5.4.4
Device status / Error messages
You can read the extended device status, in this case, current error messages, via Com-
mand “48”. The command delivers information which is partly coded in bits (see table
below).
!
Note!
You can find a detailed explanation of the device status and error messages and their
elimination on Page 100
Byte Bit Error No. Short error description ( → Page 100 )
0
0 001 Serious device error
1 011 Measuring amplifier has faulty EEPROM
2 012 Error when accessing data of the measuring amplifier EEPROM
3 not assigned –
4 not assigned –
5 not assigned –
6 not assigned –
7 not assigned –
1
0 not assigned –
1 031 S-DAT: defective or missing
2 032 S-DAT: Error accessing saved values
3 041 T-DAT: defective or missing
4 042 T-DAT: Error accessing saved values
5 051 I/O board and the amplifier board are not compatible.
6 not assigned –
7 not assigned –
2
0 not assigned –
1 not assigned –
2 not assigned –
3 not assigned –
4 not assigned –
5 not assigned –
6 not assigned –
7 not assigned –
3
0 not assigned –
1 not assigned –
2 not assigned –
3 111 Totalizer checksum error
4 121 I/O board and the amplifier board are not compatible.
5 not assigned –
6 205 T-DAT: Data download unsuccessful
7 206 T-DAT: Data upload unsuccessful
To Next Page
Loading...
