PROline Promag 53 5Operation
Endress+Hauser 79
9
0 not assigned –
1 not assigned –
2 not assigned –
3 not assigned –
4 not assigned –
5 not assigned –
6 not assigned –
7 not assigned –
10
0 not assigned –
1 not assigned –
2 not assigned –
3 not assigned –
4 not assigned –
5 not assigned –
6 not assigned –
7 401 Measuring tube partially filled or empty
11
0 not assigned –
1 not assigned –
2 461 EPD calibration not possible because the fluid's conductivity is
either too low or too high.
3 not assigned –
4 463 The EPD calibration values for empty pipe and full pipe are
identical, therefore incorrect.
5 not assigned –
6 471 Max. permitted batching time has been exceeded.
7 472 Underbatching: the minimum quantity was not reached.
Overbatching: the maximum permitted batching quantity was
exceeded.
12
0 473 The predefined batch quantity point was exceeded.
End of filling process approaching.
1 481 Actual relaxation time has exceeded the limit value.
2 482 Electrical potential of electrode 1 has exceeded the limit value.
3 483 Electrical potential of electrode 2 has exceeded the limit value.
4 not assigned –
5 not assigned –
6 not assigned –
7 501 New amplifier software version is loaded.
Currently no other commands are possible.
Byte Bit Error No. Short error description ( → Page 100 )
To Next Page
Loading...
