6 Commissioning PROline Promag 53
88 Endress+Hauser
6.2.4 “Batching” Quick Setup
This Quick Setup menu guides you systematically through the setup procedure for all
the device functions that have to be parameterized and configured for batching opera-
tion. These basic settings allow simple (one step) batching processes.
Additional settings, e.g. for the calculation of after runs or for multi-stage batching
procedures, must be made via the function matrix itself (see the “Description of Device
Functions” manual).
!
Note!
• This function is only available when the additional “Batching” software is installed in
the measuring device (order option). You can order this software from E+H as an
accessory at a later date (see Page 97).
• You can find detailed information on the batching functions in the separate “Descrip-
tion of Device Functions” manual.
• You can also directly control the filling process using the local display. During Quick
Setup, an appropriate dialog appears concerning the automatic display configura-
tion. Exit this by clicking “YES”.
This assigns special batching functions (START, PRESET, MATRIX) to the bottom line
of the display. These can be directly executed on-site using the three operating keys
(-/+/E). Therefore, Promag 53 can be fully deployed in the field as a “batch controller”
→ Page 64.
"
Caution!
The “Batching” Quick Setup sets certain device parameters for discontinuous measure-
ment operation. If the measuring instrument is used for continuous flow measurement at
a later time, we recommend that you rerun the “Commissioning” and/or “Pulsating Flow”
Quick Setup .
To Next Page
Loading...
