Endress+Hauser PROline promag 53 - A C C E S S O R I E

PROline Promag 53 8 Accessories
Endress+Hauser 97
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are avail-
able for the transmitter and the sensor. The E+H service organization can provide
detailed information on the order codes of your choice.
Accessory Description Ordering code
Transmitter
Promag 53
Transmitter for replacement or for stock. Use
the order code to define the following specifi-
cations:
–Approvals
– Degree of protection / Version
– Cable type for the remote version
– Conduit entries
– Display / power supply / operation
– Software
– Outputs / inputs
53XXX
− XXXXX * * * * * * * *
Inputs/outputs The following plug-in modules are available:
– Basic module with HART current output
– Module / 2nd slot:
Frequency output or relay output
– Module / 3rd slot:
Current output, frequency output,
relay output
– Module / 4th slot:
Relay output, status input
DK5EI
− * * * *
Software packages for
Promag 53
Software add-ons on F-Chip™, can be
ordered individually:
– Extended diagnosis
– Electrode Cleaning Circuitry (ECC)
–Batching
DK5SO – *
Mounting kit for
transmitter
Mounting kit for remote version.
Suitable for:
– Wall mounting
– Post mounting
– Installation in control panel
Mounting set for aluminum housings.
Suitable for pipe mounting.
DK5WM
− *
Cable for
remote version
Coil and signal cables, various lengths.
Reinforced cable on request.
DK5CA
− * *
Ground cable for
Promag W/P
Set consists of two ground cables. DK5GC
− * * *
Ground disk for
Promass W, P
Ground disk for potential equalization DK5GD
− * * *
Mounting kit for
Promag H
Mounting kit for Promag H, consisting of:
– 2 Process connections (see Page 151)
– Threaded fasteners
–Seals
DKH * *
− * * * *
Adapter connection for
Promag A/H
Adapter connections for installing
Promag 53 H instead of a Promag 30/33 A or
Promag 30/33 H / 1" (DN 25).
DK5HA
− * * * * * *