Promag 53 PROFIBUS DP/PA Technical data
Endress+Hauser 183
• Devices bearing this marking (PED) are suitable for the following types of medium:
Media in Group 1 and 2 with a vapor pressure greater than, or smaller and equal to 0.5 bar
(7.3 psi)
• Devices not bearing this marking (PED) are designed and manufactured according to good
engineering practice. They meet the requirements of Art.3 Section 3 of the Pressure
Equipment Directive 97/23/EC. The range of application is indicated in tables 6 to 9 in
Annex II of the Pressure Equipment Directive.
Other standards and guidelines
• EN 60529:
Degrees of protection by housing (IP code)
• EN 61010-1
Protection measures for electrical equipment for measurement, control, regulation and
laboratory procedures
• IEC/EN 61326
"Emission in accordance with requirements for class A".
Electromagnetic compatibility (EMC requirements).
• ASME/ISA-S82.01
Safety Standard for Electrical and Electronic Test, Measuring, Controlling and related
Equipment - General Requirements. Pollution degree 2, Installation Category II.
• CAN/CSA-C22.2 (No. 1010.1-92)
Safety requirements for Electrical Equipment for Measurement and Control and
Laboratory Use. Pollution degree 2, Installation Category I.
•NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control
equipment.
•NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters
with analog output signal.
•NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics.
10.1.13 Ordering information
Detailed ordering information is available from the following sources:
• In the Product Configurator on the Endress+Hauser website: www.endress.com → Select
country → Instruments → Select device → Product page function: Configure this product
• From your Endress+Hauser Sales Center: www.endress.com/worldwide
!
Note!
Product Configurator - the tool for individual product configuration
• Up-to-the-minute configuration data
• Depending on the device: Direct input of measuring point-specific information such as
measuring range or operating language
• Automatic verification of exclusion criteria
• Automatic creation of the order code and its breakdown in PDF or Excel output format
• Ability to order directly in the Endress+Hauser Online Shop
10.1.14 Accessories
Various accessories are available for the transmitter and the sensor. These can be ordered
separately from Endress+Hauser → 128.
!
Note!
For detailed information on specific order codes, please contact the Endress+Hauser service
organization.
To Next Page
Loading...
