Endress+Hauser PROline promag 53 - Installing the Promag H Sensor

Promag 53 PROFIBUS DP/PA Installation
Endress+Hauser 23
3.3.2 Installing the Promag H sensor
The sensor is supplied, as per your order, with or without installed process connections.
Installed process connections are screwed onto the sensor using 4 or 6 hexagonal-headed
bolts.
"
Caution!
Depending on the application and the length of the pipe, the sensor must be supported or
more securely mounted if necessary. Particularly when using process connections made of
plastic, it is essential that the sensor be mounted securely. A wall mounting kit for this
purpose can be ordered separately as an accessory from Endress+Hauser (→  128).
a0004301
Fig. 18: Promag H process connections; DN 2 to 25 (1/12 to 1"), DN 40 to 100 (1 ½ to 4")
A = DN 2 to 25 (1/12 to 1") / Process connections with O-ring
Weld nipple (DIN EN ISO 1127, ODT / SMS), flange (EN (DIN), ASME, JIS), flange made of PVDF (EN (DIN), ASME, JIS),
external thread, internal thread, hose connection, PVC adhesive fitting
B = DN 2 to 25 (1/12 to 1") / Process connections with aseptic molded seal
Weld nipple (DIN 11850, ODT / SMS), clamp (ISO 2852, DIN 32676, L14 AM7),
coupling (DIN 11851, DIN 11864-1, SMS 1145), flange DIN 11864-2
C = DN 40 to 100 (1 ½ to 4") / Process connections with aseptic molded seal
Weld nipple (DIN 11850, ODT / SMS), clamp (ISO 2852, DIN 32676, L14 AM7),
coupling (DIN 11851, DIN 11864-1, ISO 2853, SMS 1145), flange DIN 11864-2
Seals
When mounting the process connections, please ensure that the relevant seals are clean and
properly centered.
"
Caution!
• In the case of metallic process connections, the screws must be fully tightened. The process
connection forms a metallic connection with the sensor, which ensures a defined
compression of the seal.
• In the case of process connections made of plastic, the maximum screw tightening torques
for lubricated threads (7 Nm / 5.2 lbf ft) must be adhered to. In the case of plastic flanges,
a seal must always be used between the connection and the counterflange.
• Depending on the application, the seals should be replaced periodically, particularly when
molded seals (aseptic version) are used!
The interval between replacements depends on the frequency of the cleaning cycles and
on the temperatures of the fluid and the cleaning process. Replacement seals can be
ordered as an accessory at a later stage →  128.
A
B
C