Endress+Hauser Proline Promag L 400 - Transporting the Product

Storage and transport Proline Promag L 400
12 Endress+Hauser
5.2 Transporting the product
5.2.1 For measuring devices ≤ DN 300 (12")
!
WARNING
Center of gravity of the measuring device is higher than the suspension points of the
webbing slings.
Risk of injury if the measuring device slips.
‣
Secure the measuring device from rotating or slipping.
‣
Observe the weight specified on the packaging (stick-on label).
‣
Observe the transport instructions on the stick-on label on the electronics compartment
cover.
A0015606
• Transport the measuring device to the measuring point in the original packaging.
• Do not remove protective covers or protective caps installed on process connections.
They prevent mechanical damage to the sealing surfaces and contamination in the
measuring tube.
A0015604
5.2.2 For measuring devices ≥ DN 350 (14")
• Lift the measuring device by the flange using the metal brackets.
• If transporting by forklift, do not lift the sensor by the metal casing. This would buckle
the casing and damage the internal magnetic coils.