Endress+Hauser Proline Promag L 400 - Defining the Tag Name; Setting the System Units

Proline Promag L 400 PROFIBUS DP Commissioning
Endress+Hauser 77
System units
(→  77)
Communication
(→  80)
Display
(→  78)
Analog inputs
(→  81)
Low flow cut off
(→  81)
Empty pipe detection
(→  83)
Advanced setup
(→  84)
10.6.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
The number of characters displayed depends on the characters used.
For information on the tag name in the "FieldCare" operating tool (→  66)
1
XXXXXXXXX
A0013375
 25 Header of the operational display with tag name
1 Device tag
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the measuring point. Max. 32 characters, such as
letters, numbers or special
characters (e.g. @, %, /).
Promag 400 DP
10.6.2 Setting the system units
In the System units submenu the units of all the measured values can be set.
Navigation
"Setup" menu → System units
System units
→
Volume flow unit
Volume unit