Endress+Hauser Proline Promag L 400 - Performing Electrode Cleaning

Proline Promag L 400 PROFIBUS DP Commissioning
Endress+Hauser 89
Parameter Description Selection / User entry Factory setting
Display language Set display language. • English
• Deutsch
• Français
• Español
• Italiano
• Nederlands
• Portuguesa
• Polski
• русский язык (Russian)
• Svenska
• Türkçe
• 中文 (Chinese)
• 日本語 (Japanese)
• 한국어 (Korean)
• ةّيبَرَعْلا (Arabic)
• Bahasa Indonesia
• ภาษาไทย (Thai)
• tiếng Việt (Vietnamese)
• čeština (Czech)
English (alternatively, the
ordered language is preset in
the device)
Display interval Set time measured values are shown on
display if display alternates between values.
1 to 10 s 5 s
Display damping Set display reaction time to fluctuations in
the measured value.
0.0 to 999.9 s 0.0 s
Header Select header contents on local display. • Device tag
• Free text
Device tag
Header text Enter display header text. ------------
Separator Select decimal separator for displaying
numerical values.
• .
• ,
.
Backlight Switch the local display backlight on and off. • Disable
• Enable
Enable
10.7.4 Performing electrode cleaning
The Electrode cleaning circuit wizard guides you systematically through all the
parameters that have to be set for configuring electrode cleaning.
The wizard only appears if the device was ordered with an electrode cleaning circuit.
Navigation
"Setup" menu → Advanced setup → Electrode cleaning circuit
Structure of the submenu
Electrode cleaning circuit
→
Electrode cleaning circuit
ECC duration
ECC recovery time
ECC cleaning cycle
ECC Polarity