Proline Promag P 200
34 Endress+Hauser
Certificates and approvals
CE mark
The measuring system is in conformity with the statutory requirements of the applicable EC Directives. These
are listed in the corresponding EC Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
C-Tick symbol
The measuring system meets the EMC requirements of the "Australian Communications and Media Authority
(ACMA)".
Ex approval
The measuring device is certified for use in hazardous areas and the relevant safety instructions are provided
in the separate "Safety Instructions" (XA) document. Reference is made to this document on the nameplate.
The separate Ex documentation (XA) containing all the relevant explosion protection data is available
from your Endress+Hauser sales center.
ATEX, IECEx
Currently, the following versions for use in hazardous areas are available:
Ex d
Category (ATEX)
Type of protection
II2G Ex d[ia] IIC T6-T1 Gb
II2D Ex tb IIIC T** Db
Ex ia
Category (ATEX)
Type of protection
II2G Ex ia IIC T6-T1 Gb
III2D Ex tb IIIC T** Db
Ex nA
Category (ATEX)
Type of protection
II3G Ex nA IIC T6-T1 Gc
Ex ic
Category (ATEX)
Type of protection
II3G Ex ic IIC T6-T1 Gc
cCSAus
Currently, the following versions for use in hazardous areas are available:
XP (Ex d)
Class I/II/III Division 1 Groups ABCDEFG
IS (Ex i)
Class I/II/III Division 1 Groups ABCDEFG
NI (Ex nA, Ex nL)
Class I Division 2 Groups ABCD; NIFW*
*= NIFW parameter as per Control Drawings
To Next Page
Loading...
