Endress+Hauser Proline Promag W 400 - Carrying out a Sensor Adjustment; Configuring the Totalizer

Proline Promag W 400 EtherNet/IP Commissioning
Endress+Hauser 89
ECC duration
ECC recovery time
ECC cleaning cycle
ECC Polarity
‣
Administration
‣
Define access code
Define access code
Confirm access code
Device reset
10.7.1 Carrying out a sensor adjustment
The Sensor adjustment submenu contains parameters that pertain to the functionality of
the sensor.
Navigation
"Setup" menu → Advanced setup → Sensor adjustment
‣
Sensor adjustment
Installation direction
Parameter overview with brief description
Parameter Description Selection Factory setting
Installation direction Set sign of flow direction to match the
direction of the arrow on the sensor.
• Flow in arrow direction
• Flow against arrow direction
Flow in arrow direction
10.7.2 Configuring the totalizer
In the "Totalizer 1 to 3" submenu the individual totalizer can be configured.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to 3
‣
Totalizer 1 to 3
Assign process variable
Unit totalizer