Endress+Hauser Proline Promag W 400 - Page 99

Proline Promag W 400 EtherNet/IP Commissioning
Endress+Hauser 99
2. Setting the write protection switch (WP) on the main electronics module to the ON
position enables the hardware write protection. Setting the write protection switch
(WP) on the main electronics module to the OFF position (factory setting) disables
the hardware write protection.
 If hardware write protection is enabled, the Locking status parameter displays
the Hardware locked option. In addition, on the local display the -symbol
appears in front of the parameters in the header of the operational display and in
the navigation view.
X X X X X X XX X
20.50
XX
XX
A0015870
If hardware write protection is disabled, no option is displayed in the Locking
status parameter. On the local display, the -symbol disappears from in front of
the parameters in the header of the operational display and in the navigation
view.
3. WARNING! Excessive tightening torque applied to the fixing screws! Risk of
damaging the plastic transmitter. Tighten the fixing screws as per the tightening
torque →  32.
Reverse the removal procedure to reassemble the transmitter.